I know how to put fuel in both tanks,
http://www2.towerhobbies.com/cgi-bin...9&I=LXK136&P=K That was the part that wasn't so hard. Just pressure to get the fuel to the engine. These should fit below a false fuel cap. Getting the fuel to the engine is my biggest concern.
Now if I can get the big tanks in the wings???
I have read that the Saito fires both at the same time too, I am just clueless when it comes to the pressure part of that. I think a phone call to a knowledgeable person at Perry is in order. Maybe a conference call between a Saito and Perry engineer would benifit them both greatly?? I dont know.
I do know that before I go much farther I need to get the engine and build the test stand to see if the pump on the BME 90 is strong enough for 2 tanks. I need some balsa to cut wing ribs and a spar to check my fuel tank and wing for strength. Too complicated