Pardon me for jumping in here...I've been lurking and following this thread since I am building a T60 Deluxe right now. I'm at the point of cutting out the wheel wells for the retracts. I would be interested if anybody knows where I could find a commercially available molded wheel well kit that would work with this kit? While I know I could eventually come up with a passable balsa lining as called for, I would prefer to just spring for a really nice pre-molded item...maybe something available as a replacement part that is intended for an ARF. I'm using the recommended 2 1/2" wheels with a 3" cutout (I've already made the cutout...)

Any ideas?

P.S. I liked the idea that krossk came up with in regards to dual wing pins as opposed to the single! I built the CG Protege which has pretty much the exact same wing design (minus retracts, of course) and it has a single pin. I built it as called for with a single pin and have always felt like it might be a bit of a problem down the road.... I'm paying close attention to all mods being done in this build thread!