Dear All,

Long time reader fist time poster.

I have just purchased and received off Ebay a HL non S&S Tiger 1.

The included battery is rated at 1700mAh and the included charger is rated at 500mAh. I therefore charged the battery for 3.4 hours (3hours 24 minutes)

After 5 minutes of use the tank pauses with flashing lights.

Having trawled through this forum I am led to understand that the most likely causes are:

* battery not being charged/depleted
* transmitter batteries are no good
* crystals are wrong or no good
* faulty transmitter
* faulty tank board

If I were to go the full S&S upgrade how do I map across the wiring from the old (non S&S) board to the new (S&S) board?

I know this has been discussed many times before, but I have not been able to find a pictorial 'how to' guide for this so apologies up front if anyone gets annoyed.

I appreciate that this is an enormous task, but can someone PLEASE, PLEASE, PLEASE provide a step by step pictorial 'how to' guide on how to convert a non S&S HL tank to a S&S HL tank?

Your assistance in this matter is greatly appreciated as based on this knowledge I am hoping to upgrade a WS T-34 to HL/airsoft standard


Many thanks

Fury 25