RCU Forums - View Single Post - Two elevator servos
Thread: Two elevator servos
View Single Post
Old 05-18-2007 | 05:19 PM
  #4  
wildchild45177's Avatar
wildchild45177
Senior Member
My Feedback: (11)
 
Joined: Jul 2005
Posts: 476
Likes: 0
Received 0 Likes on 0 Posts
From: wilmington, OH
Default RE: Two elevator servos
If you mean faster then move it from channel 8 to channel 5. If you mean further then got to the end point adjustment for channel 8. This is assuming that your physical setup is correct.

Bob
wildchild45177 is offline  
Reply Like