ORIGINAL: larry11
not sure where to post, in jetcat support or here. So, here it goes.
Before I went to fly this Saturday after my preflight inspection I noticed the blades on the intake must of ingested something earlier.
I didnt start it after I noticed it. Although the rotating assembly turns fine by hand without any roughness.
Should I send it in to have it gone through? What should I do? I have it in a baby boomerang and am not using a fod screen.
Please look at the pictures and advise.
Thanks,
Larry
Larry
Boomerang always had done a lot of damage to engine running without FOD screen. There is too much loose stuff in the wood fuselage.
Send the engine back and get the FOD put it in before running again in the Boomerang.