Hey Guys,

I've had this plane since the fall and have not been able to get it to fly. Snapped on first take off and broke wing. Replaced wing and tried to fly today, same results. After putting the pieces back together we figured out that the wings washout is not correct. Looking from the back the left side is lower than the right. Both wings were put together according to the instructions. There is not much room for error with the hardwood joiner. I feel that the center fiberglass section is not made right. We had cut down most of the elevator to keep it from snapping. What really happened is that the left side of the wing stalled and caused the plane to roll. The wing is junk again but the fuse is repairable, we will see what Tower's Hobby Services has to say on Monday.

R/C Foolish