Yea, that picture is pretty confusing. Here are some pictures taken from directly in front, at a 45 degree angle looking down the camera mount arm, and directly from the right side. The last picture is how I aligned the camera. First the camera pod was set to point downward at a 45 degree angle. Then the SAVS was set on the table with its arms horizontal/perpendicular to the seam on the floor. The T-square was placed perpendicular to the seam, and directly along the forward axis line of the camera (7 1/2" right of the DF center line). The camera was adjusted so that the seam was horizontal and the camera was looking straight forward, down the ruler. This angle seems to be a very good compromise, and hopefully we won't have to change it too much. I'm editing some video bits shot with this angle and I'll post them in a little while.