RCU Forums - View Single Post - CP Performance Help
View Single Post
Old 07-14-2007 | 02:08 PM
  #3  
Not24's Avatar
Not24
Senior Member
My Feedback: (1)
 
Joined: Dec 2002
Posts: 999
Likes: 0
Received 0 Likes on 0 Posts
From: Gloucester, VA
Default RE: CP Performance Help


ORIGINAL: HeliWill

I bought the Blade CP about a year ago on the notion that it would really perform as intended. I got all the aerobatic upgrades, installed them, did about three flights, and put it in storage. I was very unhappy with the power and head speed.

Is anyone making 3D blades? Any engine recommendations? Any suggestions? I’d like to put it out of moth balls.

Thanks
I'm the same way. If I had it to do over again, I would not have spent the money on this bird, and I would have gotten a Honey Bee King 2. The dual motor heli's are always going to be sub-par in comparison. I'm ready for more power so I can fly like the big boys. This one flies like a cub. It will loop, but only after diving. It's fun to chase the horses around the pasture, but that's about all it's good for. I figure it will cost another $200 to go brushless, direct drive tail, and telebee gyro. That also includes going with a conventional receiver and adding a speed control. I just don't think it's worth it.