Not a silly question about wires being in the right place at all.I even question myself on if I have the power wires going to the right place on this board.I'm almost ready to open up one of my other tanks to do a comparrision on the wiring.It acts like it is not getting the power to all the proper places.I did not hook up the white wire.Will post some pictures of the board,although my camera is not the best.Tried it inside and outside to keep the flash from working but they don't look that clear. Thanks--I will PM you a little later.
BIGMIG [:-][:-][:-]
Just went to look at the board again while these pictures were loading.On the board right below where i have the wires soldered,there are 4 sets of (three pins sticking up) and the places I have the wires go to the center of each of the three pin combination.Hope i'm making sense the way I have tried to explain this.----------