RCU Forums - View Single Post - Remote sensitivity with Cline?
Thread: Remote sensitivity with Cline?
View Single Post
Old 03-22-2003 | 06:39 PM
  #3  
Bski
Junior Member
 
Joined: Jul 2002
Posts: 22
Likes: 0
Received 0 Likes on 0 Posts
From: Salisbury, MD,
Default Wrong prop size
My mistake. I should've checked earlier. I'm running a 16x8 prop.

Thanks outssider. When turning the needle in, I do get a slight decrease in RPM (I'm not sure where that is) but I've been afraid to go in any further for fear of running too lean. If I was to turn it too far just to find where the too lean setting was, will I hurt the engine?

B-ski
Bski is offline  
Reply Like