RCU Forums - View Single Post - How to convert an ATX power supply to rc use
Thread: How to convert an ATX power supply to rc use
View Single Post
Old 10-08-2007 | 06:14 PM
  #38  
mrasmm
Senior Member
 
Joined: Jan 2007
Posts: 4,432
Likes: 0
Received 0 Likes on 0 Posts
From: Sometown, Northern Utah
Default RE: How to convert an ATX power supply to rc use

ORIGINAL: Savage03

What about the light bulb method? Any comments on using those? The one guy said his was ok with it, I assume its a 1157 bulb? Im heading to my electronics shop now and will grab the 4 1 ohm resistors anyway just incase the bulb idea is no good. Thanks.

yeah, the lightbulb method is fine =) Not sure on the bulb number, I know it's been posted here and there a few times. Alot of people like the bulb because it shows them that the PSU is on. Just get one that is good for a good one amp draw at 5V.
mrasmm is offline  
Reply Like