I think both my servos are fried. I got ready to go the track last night and charged my batteries and stuff. And this morning when I went out to the track I turned my hyper on and nothing happened. I made sure the reciever was on and the transmitter and NOTHING! I thought maybe the battey took a dump on me and did not hold a charge so I left that alone and ran other stuff. When I got back home I removed the battery and put in my 8ight and monsoon and it worked fine, so I thought maybe the reciever was bad. I took a spare servo and plugged it in the reciever and it worked fine (throttle and steering) I connected the servos that were not working in monsoon and they did not work. What could cause this? The only thing I can think of is that I have a pigtail on the battery so I can charge it without disconnecting it from the on/off switch or reciever, if I by mistake left the switch on and charged it would the charge have gone into the servos and messed them up or is it something else? I have the same thing on my 8ight buggy and have not had a problem. Please help. It just cost me about 100.00