RCU Forums - View Single Post - Setting gear mesh on Matrix
Thread: Setting gear mesh on Matrix
View Single Post
Old 11-26-2007 | 09:42 PM
  #2  
revopqrs's Avatar
revopqrs
Senior Member
 
Joined: Jun 2005
Posts: 1,366
Likes: 0
Received 1 Like on 1 Post
From: durham, NC
Default RE: Setting gear mesh on Matrix
sounds too tight? hold the spur and wiggle the clutch bell, there should be a little tic between the gears. not touching.
revopqrs is offline  
Reply Like