Can one of you guys look in your gee-bee instruction manual and tell me if
I am wrong? I have already made the elevator push-rods..

http://manuals.hobbico.com/gpm/gpma1326-manual.pdf
Page 26

Now I am reading for the rudder rod it .. Is at 6.5 inches (for the threaded part)

And 8 inches for the non- threaded part? (LOOK) at #24 and what throws me off
is #27 (says non-threaded) Then look at #30... kinda confusing.

So I am thinking it is a misprint..

I should have 2 rods with 6.5 (threaded) and 7.5 inches
and one rod at 6.5 (threaded) and 8 inches.

Thanks for your help,
Jeff