RCU Forums - View Single Post - 35% DA-100 Mounting
Thread: 35% DA-100 Mounting
View Single Post
Old 01-26-2008 | 07:17 PM
  #2  
rctom's Avatar
rctom
Senior Member
 
Joined: May 2002
Posts: 6,189
Likes: 0
Received 2 Likes on 2 Posts
From: Flower Mound (near Dallas), TX
Default RE: 35% DA-100 Mounting
My mounting kit is done by epoxying 3/4" square oak to a ply plate, then I cut it to the proper length and drill the oak.

It's like having standoffs except that it can't rock back and forth. It's done in 2 pieces (top and bottom) leaving the sides clear to get at the carb for adjustments.

Photos below.

TF
Attached Thumbnails Click image for larger version Name: Zw69785.jpg Views: 19 Size: 137.9 KB ID: 861868   Click image for larger version Name: Hy34988.jpg Views: 18 Size: 145.6 KB ID: 861869  
rctom is offline  
Reply Like