RCU Forums - View Single Post - setting gcontrol surface movement
Thread: setting gcontrol surface movement
View Single Post
Old 02-14-2008 | 09:18 PM
  #1  
mazjag
Senior Member
 
Joined: Jan 2008
Posts: 226
Likes: 0
Received 0 Likes on 0 Posts
From: marietta, GA
Default setting gcontrol surface movement
hey guys,can someone give me a quick lesson on setting control surface movements.I`m setting up a mini pulse and it calls for 9mm in low rate.is that 9mm in one direction off of center? or is that 9mm from lets say full up elevator to full down? any help would be great...thanks..jason
mazjag is offline  
Reply Like