RCU Forums - View Single Post - Composites class
Thread: Composites class
View Single Post
Old 03-07-2008 | 06:58 PM
  #8  
lz-23
 
Joined: Jun 2007
Posts: 243
Likes: 0
Received 0 Likes on 0 Posts
From: Chicago, IL
Default RE: Composites class

ORIGINAL: jeffk464

I'm going to build similar to what this guy is doing with a yak, but I will be using wood and foam rather than all foam.
Hey, thanks. I could use wood too, but this foam was at hand and decide to give it a shot. It turns out well so far. I did print all parts on tabloid size laser jet. Only couple of gluing was require to get full size plans. May be next one will be all wood too. What size your FW is going to be?
lz-23 is offline  
Reply Like