RCU Forums - View Single Post - Four-Cycling a Two-Cycle Engine
Thread: Four-Cycling a Two-Cycle Engine
View Single Post
Old 03-10-2008 | 11:15 PM
  #7  
estradajae
Senior Member
 
Joined: Nov 2005
Posts: 778
Likes: 0
Received 2 Likes on 2 Posts
From: MedellinAntioquia, COLOMBIA
Default RE: Four-Cycling a Two-Cycle Engine


Breaking in is usually done at WOT,

Take a look a this thread....this describes a proper break-in procedure!! [link=http://www.rcuniverse.com/forum/Tapered-Bore_Engine_Break-in_-_Upgraded/m_1850473/tm.htm]Tapered bore breaking in by Dar Zeelon[/link]

Jorge

estradajae is offline  
Reply Like