RCU Forums - View Single Post - Lifted edges on covering
Thread: Lifted edges on covering
View Single Post
Old 04-28-2003 | 11:01 PM
  #3  
SDR-Hammer
Senior Member
 
Joined: Sep 2002
Posts: 683
Likes: 0
Received 0 Likes on 0 Posts
From: , MI
Default Lifted edges on covering
CA is what I've done in the past, but I always seem to make a mess pressing the covering down and squeezing the CA out.

I've never used trim solvent before and wasn't sure if it would work in this situation?
SDR-Hammer is offline  
Reply Like