RCU Forums - View Single Post - Well, here she is!
Thread: Well, here she is!
View Single Post
Old 04-30-2003 | 04:35 PM
  #3  
dega500
Member
 
Joined: Dec 2002
Posts: 75
Likes: 0
Received 0 Likes on 0 Posts
From: Pinson, AL
Default Well, here she is!
Hi Mindwarp

I just finished my LT-40. I just want to share that the most valuable building tool I have is a small thermometer to measure the actual temp. of the irons when covering. Those dials on the irons are not accurate at all. I am new to this but I bet that most of the problems people have with covering stems from temps being too hot and the covering starting to shrink before it gets stuck down good. GOOD LUCK!

Mike E
dega500 is offline  
Reply Like