I hate bending pushrods cause I never get the right legnth. I have been using the great planes ez lock connectors. The ones that have the pin that gets a metal backing like an earring. Then the pushrod goes into the hole and screws down.

Meh, here is a link to what I am talking about but I am sure you guys know.

http://www3.towerhobbies.com/cgi-bin...?&I=LXK098&P=0



But I see a lot of these "ball links" like the one below but just by looking at the picture, I dont see how they attach to the pushrod and the servo arm. Someone wanna clue me in? Maybe a picture of one actually installed?

http://www3.towerhobbies.com/cgi-bin...?&I=LXK093&P=0

or

http://www3.towerhobbies.com/cgi-bin...?&I=LXK096&P=0


I had an ez lock come off before. It only happened once and I found it on a pre-flight check, but I am kinda worried about using them again.