RCU Forums - View Single Post - graphtec r/c
Thread: graphtec r/c
View Single Post
Old 05-01-2008 | 11:32 AM
  #8  
103/17
Senior Member
 
Joined: Sep 2006
Posts: 442
Likes: 0
Received 0 Likes on 0 Posts
From: Lancaster, NH
Default RE: graphtec r/c

I had my gear delivered today. I guess it's OK maybe my expectations were too high. The two sides are not uniform in width or shape. The curved profile is even different by about 3/16 in the center if you hold them together and compare. The sides are finish sanded but show some rough sanding underneath. I can finish sand and it will look better but I think it should have been sanded a little better. The high gloss finish would have been excellent had it not been for a big dull sand mark the size of a quarter on one top surface mid way down the leg. I guess they are better than the stock gear at this point but I was looking for a better more professionally finished product. Maybe my experience is different than others. They do look to be sturdy and the laminate looks nice.............

103/17