Here are a few more photos of the Do 335 build. I finished the removeable tail section and have most of the sheeting finished on the fuze. The front hatch is also sheeted. I have the wings ready to sheet next. Trying to figure out if I want to glass or use a fabric covering? I want to keep the weight down as much as possible on this one to make sure I get a good flyer. Leaning towards using an iron-on covering material to save weight and if it looks bad I can always glass it later.


http://lh6.ggpht.com/JeffreyMohn/SCx...JPG?imgmax=800

http://lh4.ggpht.com/JeffreyMohn/SCx...JPG?imgmax=800

http://lh6.ggpht.com/JeffreyMohn/SCx...JPG?imgmax=800