RCU Forums - View Single Post - Kevlar
Thread: Kevlar
View Single Post
Old 05-27-2008 | 01:06 PM
  #9  
Miguel Santana's Avatar
Miguel Santana
My Feedback: (6)
 
Joined: May 2002
Posts: 1,139
Received 1 Like on 1 Post
From: Santo Domingo, DOMINICAN REPUBLIC
Default RE: Kevlar
Ok...I guess I´ll buy a few cheap scissors.
Did you applied all layer at onces?...or each layer was a new epoxy mix?
How about using several layer of 1.7 oz intead of a few of 3.3?
Does this material remain well at the mold corners? ...I´m planning use the positive mold technique...
Tks,
MS
Miguel Santana is offline  
Reply Like