RCU Forums - View Single Post - Source for floats
Thread: Source for floats
View Single Post
Old 06-01-2008 | 09:33 PM
  #7  
Shack
Junior Member
 
Joined: Jun 2007
Posts: 19
Likes: 0
Received 0 Likes on 0 Posts
From: Lexington, SC
Default RE: Source for floats
I just got a set of floats from [email protected] . A nice pair of "slim" 42" beauties for my Saito FA-82a powered LT-40 ARF.

I took the advice of some on this forum & used "Minwax Polycrylic" water based to glass over 3/4 oz. cloth. Cleans up w/ water, goes on easy, dries fast [use a hair dryer].

Painted using "Ace Hardware's" spray primer. then their premium enamel [dries fast], then a coat of "Minwax Spar Urethane" spray [clear] for fuel proofing.

Did all this in one day.

Shack
Shack is offline  
Reply Like