RCU Forums - View Single Post - 3D Model for a Saito 1.25 4-Stroke
Thread: 3D Model for a Saito 1.25 4-Stroke
View Single Post
Old 06-11-2008 | 01:35 PM
  #13  
octanehuffer's Avatar
octanehuffer
 
Joined: Jul 2006
Posts: 922
Likes: 0
Received 0 Likes on 0 Posts
From: Lakeland, MN
Default RE: 3D Model for a Saito 1.25 4-Stroke
The only thing not used was the wheel pants. I have a spinner nut on the end of the crankshaft. 2200 mAh Li-po pack. I dont think I used anything special on this one.
Adam
octanehuffer is offline  
Reply Like