Mikie888,

the address for RS engines is , http://www.rsengines.net/

If I had a lathe of my own I could make my own prop hubs, turn down flywheels , ect. Unfortunatly I dont ( yet) but maybe something to shoot for in the future.

The guys at RS engines are great, very helpfull, and very quick to respond to any questions you have. They also have carbs, plugs , and other items not listed on the web site. Just shoot them an e-mail .


Aneat:
I thought of trying to cut the flywheel with the saw and file method, but wasnt to trusting as to weather or not it would throw off the balance. Have you or anyone else tryed this with good results? I almost did, but was a little bit too affraid of possible shrapnal flying around.

David