RCU Forums - View Single Post - DL-50 engine
Thread: DL-50 engine
View Single Post
Old 08-30-2008 | 08:29 PM
  #2749  
NUTNDUN's Avatar
NUTNDUN
Senior Member
 
Joined: Dec 2006
Posts: 159
Likes: 0
Received 0 Likes on 0 Posts
From: Newville, PA
Default RE: DL-50 engine
The high end was about an 1/8 turn lean from factory and the low needle was a hair over 1/4 turn lean from factory
NUTNDUN is offline  
Reply Like