We also are laser cutting the Turbinator-e. After making a test run, I found that almost all the parts are off on the cut sheet. F-5 is way out, actually unusable. I am now redrawing all the cut parts on Sheet 2. I also am providing a short kit of all the cut parts on sheet 2, along with the canopys for $75. I also make the retracts specifically for the Turbinator-E. The mains are 85 degree, and the nose gear is plate mount. They drop right in place oft Robarts, no changing is required. The retracts are $ 150 and come with all the support hardware. This offer is only available if you purchase the short kit at the same time. Interested partys can contact me at [email protected] or call at 407-381-8060






Larry E.
SouthEast Model Products
Orlando, Fl.