RCU Forums - View Single Post - PC-9 seagull models need specs
Thread: PC-9 seagull models need specs
View Single Post
Old 07-13-2003 | 04:30 AM
  #4  
mdmrider
Junior Member
 
Joined: Jun 2003
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
From: coldwater, MS,
Default pc9 c g
cg is at 8cm, from leading edge fus, rudder 3/4 from center elavator is at 3/4 from center ali is at 3/16 up&down i hope this helps
mdmrider is offline  
Reply Like