RCU Forums - View Single Post - make Rivets in fiberglas surface?
Thread: make Rivets in fiberglas surface?
View Single Post
Old 09-23-2008 | 03:50 PM
  #12  
Carbon-Customs's Avatar
Carbon-Customs
Senior Member
 
Joined: Sep 2004
Posts: 500
Likes: 0
Received 0 Likes on 0 Posts
From: DENMARK
Default RE: make Rivets in fiberglas surface?
im pretty sure that on a russian bird they should feels like a nail not totally hammered in the pro mark stuff looks good, but i want it in the surface..

about the brass tube, on the F18 you just simply melt rivets direct on the fiberglass surface right?
Carbon-Customs is offline  
Reply Like