RCU Forums - View Single Post - make Rivets in fiberglas surface?

09-23-2008 | 07:14 PM

#18

sweetpea01

My Feedback: (10)

Joined: Oct 2003

Posts: 3,349

Likes: 0

Received 1 Like on 1 Post

From: Lebanon OH

RE: make Rivets in fiberglas surface?

I burned mine with a soder iron and brass. I sharpened the brass though so it would go in easier and I could twist.

I didn't use a template so mine are not the straightess out there but it was the first time I did it. I did make a stand for it with a dial to adjust the power (thus the heat).

This is my TF P-47

Attached Thumbnails

Click image for larger version

Name: Xv63693.jpg
Views: 93
Size: 107.3 KB
ID: 1039762

Click image for larger version

Name: Sn39739.jpg
Views: 86
Size: 35.7 KB
ID: 1039763

Reply Like