RCU Forums - View Single Post - Overloading an engine
Thread: Overloading an engine
View Single Post
Old 10-12-2008 | 05:33 AM
  #42  
gkamysz's Avatar
gkamysz
Senior Member
My Feedback: (19)
 
Joined: Jun 2003
Posts: 3,397
Likes: 0
Received 2 Likes on 2 Posts
From: Crystal Lake, IL
Default RE: Overloading an engine
ORIGINAL: DarZeelon

I did not actually state any torque values; just comparative numbers, to show if torque is higher at one point than it is at another.
Dar, this is ridiculous. If you are stating HP values, there are torque values to go along with them since we know what RPM they were produced at. You just neglected to convert the number to a common unit.
gkamysz is offline  
Reply Like