RCU Forums - View Single Post - Overloading an engine

10-12-2008 | 05:54 AM

#43

DarZeelon

Senior Member

Joined: Apr 2003

Posts: 8,913

Likes: 0

Received 6 Likes on 6 Posts

From: Rosh-HaAyin, ISRAEL

RE: Overloading an engine

Quote:

ORIGINAL: gkamysz

Dar, this is ridiculous. If you are stating HP values, there are torque values to go along with them since we know what RPM they were produced at. You just neglected to convert the number to a common unit.

True, Greg.

...But since I entered that whole mumbo jumbo regarding the 5,252.1 (...), I did not want to get into fractional torque values in lbs.ft., or to use oz.in...

So, yes, I did neglect to convert, but since I looked for the highest value, A>B is just as good as 1.31>1.19...

Reply Like