RCU Forums - View Single Post - Mechanical settup problem with ve tail
Thread: Mechanical settup problem with ve tail
View Single Post
Old 10-24-2008 | 06:28 PM
  #1  
fossoman
Senior Member
 
Joined: Feb 2006
Posts: 251
Likes: 0
Received 0 Likes on 0 Posts
From: timbuk 2, IA
Default Mechanical settup problem with ve tail
Ive never had this problem in the past and need some insight. When adjusting my Tail servo on the boom I cant seem to get it right. in standard rate mode the tail wanders a little in both directions real slowly. it can go either way. GY401 Futaba S9650 tail servo. CNC Aluminum upgrade servo mount. My rotor blades are a little out of balance can that cause this. Its not bad in Headlock mode but there is a slight wandering which I want to get rid of. Whats A good gain setting for standard rate. Im using a spektrum DX6 AR 6000 receiver
Would appreciate any help .
Happy Flying
fossoman is offline  
Reply Like