RCU Forums - View Single Post - Mechanical settup problem with ve tail
Thread: Mechanical settup problem with ve tail
View Single Post
Old 10-24-2008 | 11:22 PM
  #5  
KCinNC's Avatar
KCinNC
Senior Member
 
Joined: Aug 2007
Posts: 556
Likes: 0
Received 0 Likes on 0 Posts
From: LKN, NC
Default RE: Mechanical settup problem with ve tail
i have the same setup, mine has a very very slight drift in HH mode, but it is only noticeable if i let it sit in a hover 3 minutes straight.

i didn't set the gyro/servo up in rate mode either...i just did the finless setup and it worked
KCinNC is offline  
Reply Like