RCU Forums - View Single Post - AMT EDT Crapped Out!
Thread: AMT EDT Crapped Out!
View Single Post
Old 11-03-2008 | 06:33 AM
  #8  
Henk Visser's Avatar
Henk Visser
 
Joined: May 2005
Posts: 457
Received 0 Likes on 0 Posts
From: drachtenFriesland, NETHERLANDS
Default RE: AMT EDT Crapped Out!
ORIGINAL: Woketman

I have a Mercury that has been in storage for well over two years. I fired it up today to check out prior to putting it into a Boomerang Sprint. It ran great, but the EDT is all black on its display, as if the contrast were turned up way too high. Also, it is not powering itself off after 15 or 20 minutes like it is supposed to. It stayed black for at least 1.5 hours. Anyone have any ideas what is wrong? Any similar failures and solutions? I can run the turbine, but I have no feedback for RPM or temps (I'd sure like to).

Thanks guys.

Hi i have had the same problem with my AMT mercuy edt from the netherlands.
I contacted Benny and he told me to send it in after 2 days he called me it was ready to go again!
He swapt out something don't remember what exactly but it was much cheaper than a new one!
So send it in
Henk Visser is offline  
Reply Like