RCU Forums - View Single Post - Does the Brillelli 46 motor need to be timed?
Thread: Does the Brillelli 46 motor need to be timed?
View Single Post
Old 02-27-2009 | 08:18 PM
  #14  
w8ye's Avatar
w8ye
My Feedback: (16)
 
Joined: Dec 2001
Posts: 37,576
Received 11 Likes on 10 Posts
From: Shelby, OH
Default RE: Does the Brillelli 46 motor need to be timed?

ORIGINAL: JoeAirPort

Here's what I like lately. Works great.

1) Set throttle to 1/3 throttle. Choke closed, ignition on. Flip until it pops (up to 10 flips for the first start of the day starting with no fuel in the tank).
2) Set throttle to high idle. Choke off. Flip 2-3 times and it always starts up.

After that it always starts the 1st flip no choke. It depends on the engine, needle settings, and temp outside. I always shut my engine down with the ignition switch to make sure there's fuel right there for the next start.
Used this for many years on chain saws. It works on gas model engines too
w8ye is offline  
Reply Like