RCU Forums - View Single Post - LT40 Build thread
Thread: LT40 Build thread
View Single Post
Old 02-27-2009 | 11:07 PM
  #39  
w8ye's Avatar
w8ye
My Feedback: (16)
 
Joined: Dec 2001
Posts: 37,576
Received 11 Likes on 10 Posts
From: Shelby, OH
Default RE: LT40 Build thread
I managed to bend my 1/16" tail wire 90 degrees OK with two pairs of pliers. I had to think about that for a little bit before I did it. Wasn't too hard
w8ye is offline  
Reply Like