RCU Forums - View Single Post - Degrees into inches to setup controls
Thread: Degrees into inches to setup controls
View Single Post
Old 03-31-2009 | 07:23 PM
  #10  
Jetdesign's Avatar
Jetdesign
My Feedback: (8)
 
Joined: May 2008
Posts: 7,056
Received 0 Likes on 0 Posts
From: Honolulu, HI
Default RE: Degrees into inches to setup controls

ORIGINAL: szig

Take a look, this could help you:

http://www.carbidedepot.com/formulas-trigright.asp
If using this, we know side C (width of control surface) and angle B (throw), and are looking for side A (throw in inches)
Jetdesign is offline  
Reply Like