RCU Forums - View Single Post - Evolution 58GX2 prop question
Thread: Evolution 58GX2 prop question
View Single Post
Old 04-07-2009 | 07:04 PM
  #1  
rcplanenut
My Feedback: (12)
 
Joined: Dec 2003
Posts: 339
Likes: 0
Received 1 Like on 1 Post
From: Murray, KY
Default Evolution 58GX2 prop question
Does anyone know where I can find a prop drilling fixture for this motor. Its a 6 bolt pattern. not sure if its the same as DA or3W. Any suggestions on a good prop to use. Its going on my H9/Carden Yak

Hide Signatures
rcplanenut is offline  
Reply Like