RCU Forums - View Single Post - Does Thin CA Work With Plywood?
Thread: Does Thin CA Work With Plywood?
View Single Post
Old 04-30-2009 | 12:03 PM
  #4  
Fishin Geezer
Senior Member
 
Joined: Oct 2007
Posts: 270
Likes: 0
Received 0 Likes on 0 Posts
From: Grants Pass, OR
Default RE: Does Thin CA Work With Plywood?
Thanks Mike and iflyg450. I'm about to start glueing the fuselage of my CG Tiger 60. The manual says to assemble the parts with rubber bands, then glue it when everything is adequately lined up. I can't open the joints and put glue on the mating surfaces. Will it be strong enough if I just apply a fillet of yellow glue to both sides of each joint? This my second Tiger 60 but the first one crashed on its second flight so I didn't learn how strong the fuselage was!!

I did learn how strong it wasn't! .

Frank
Fishin Geezer is offline  
Reply Like