RCU Forums - View Single Post - Converting .18tz pullstart to bumpstart
Thread: Converting .18tz pullstart to bumpstart
View Single Post
Old 05-08-2009 | 02:54 AM
  #1  
sanjeevraj
Junior Member
 
Joined: Sep 2008
Posts: 11
Likes: 0
Received 0 Likes on 0 Posts
From: johor bahrujohor, MALAYSIA
Default Converting .18tz pullstart to bumpstart
Hi,

Can anyone tell me if i would be able to replace the pullstart with a back plate without changing the crankshaft. i currently have the engine with the rotary carb. Being used in a Hpi rs4
Please do highlight if there are any other requirements.

im planning to get this http://www3.towerhobbies.com/cgi-bin...?&I=LXJPZ5&P=Z

thanks
Sanjeev
sanjeevraj is offline  
Reply Like