RCU Forums - View Single Post - Modification to be done on a UCD 3D 60-90
Thread: Modification to be done on a UCD 3D 60-90
View Single Post
Old 06-21-2003 | 02:37 AM
  #19  
rajul's Avatar
rajul
Moderator
My Feedback: (58)
 
Joined: Jun 2002
Posts: 8,251
Likes: 0
Received 3 Likes on 3 Posts
From: Missouri City, TX
Default Modification to be done on a UCD 3D 60-90
Yeah the 493 is a simpler and lighter setup. Just checked the catalog and it says "5-40x1-1/2" round head screws", not 6-32. Perhaps I'll go for this one as it is also much cheaper than the 867. BTW, just ordered two rolls of kevlar from EMS......
rajul is offline  
Reply Like