In my Elan I am using all digital servos except for the Brake and gear valves. I have binded the receiver(9100)to the sevos in the position I want the servos to come on during power up.

Every servo except for those two stays in the position which I binded them. The Gear valve servo makes a quick movement one way then back to the position I have the gear switch in during turn on. Because of this movement my gear will cycle.
These servos are Hitec 635's I dont believe they have their own failsafe.

I can't figure out why these two servos are acting the way they do. Shouldn't the binding take care of there movement?

Any Ideas out there?

Thanks,
Stan