Here's a shot of my menace boom and wing before I put on the trailing edge... Simular to the Stickit, except the wing halves are build separately and then glued to the pod and boom.




Here it is after the trailing edge is installed:



The StickIt is just a little bit different... Again the wing halves are build seperately... Make sure to let the spar's hang ove the egde by 1/4" so that they can index into the pod. Then just epoxy both wings halves in. A 1/4 spruce brace goes in at the spar line the width of the sheeted area. I think the sheeting goes on next. On the stickit IV, the top half of the sheeting on the top of the wing is a giant hatch... Like this:




More pics:

Stickit Pictures

Menace Pictures

More Menace Pictures