RCU Forums - View Single Post - What Engine should o chose?
Thread: What Engine should o chose?
View Single Post
Old 06-29-2003 | 02:41 PM
  #9  
Legendary
Senior Member
 
Joined: May 2003
Posts: 496
Likes: 0
Received 0 Likes on 0 Posts
From: Monee, IL,
Default Do a search in this forum about the .26
There is about the same (50/50) good and bad said about it! As far as the conversion kit goes XTM makes IMO the most complete kit out there! It comes with steel CVD's and drive shafts so there is no need to buy those. I would get a steel spur gear and a MG high tourq steering servo! I have 2 XTM conveted Maxx's one with a Torq .21 and the other with a Force .25 and both rock!
Legendary is offline  
Reply Like