RCU Forums - View Single Post - anyone converted a slash to nitro?
View Single Post
Old 09-19-2009 | 02:18 PM
  #5  
dittch
Banned
 
Joined: Aug 2006
Posts: 454
Likes: 0
Received 0 Likes on 0 Posts
From: Lafayette, IN
Default RE: anyone converted a slash to nitro?


ORIGINAL: SyCo_VeNoM

I doubt 1/3rd metal would be enough seeing the whole chassis acts as a heatsink on nitro but I might be wrong. But that is just my idea.
Actually, there are several nitro vehicles where only the back half of the chassis is metal, two traxxas vehicles come to mind that fit into that category: nitro sport, stampede. I plan on running the metal up past the engine and ending at the gas tank, a little less than half way up the chassis from the rear.