RCU Forums - View Single Post - anyone converted a slash to nitro?
View Single Post
Old 09-19-2009 | 02:28 PM
  #7  
dittch
Banned
 
Joined: Aug 2006
Posts: 454
Likes: 0
Received 0 Likes on 0 Posts
From: Lafayette, IN
Default RE: anyone converted a slash to nitro?


ORIGINAL: Chris_RC

It would be ALMOST impossible but not 100% impossible if that makes sense.
I agree that it will be a little tricky, but almost impossible? I have to disagree with that. I don't think a job like this is anywhere near the point of impossible. Personally, on a scale of 1 to 10 (1 being easy, 10 being impossible), I would rate it a 5

I'm keeping my eye on ebay for a slash roller. Once I get it I'm trying this....not only am I going to try it, I'm going to do it and make it work well.

thanks for all the comments everyone