ORIGINAL: sc204
Is there a servo that could be used in the small cutouts provided? The Integral directions lists a cutout that would fit the 3421 without modification. 15 x 32. If this is the smallest size servo that someone might choose then I think it would be no different for the manufacturer to make the opening that size. (Monor point on a nicely produced airplane)
On another note I was waiting for some 3mm threaded rod. I ordered a couple of pieces from McMaster Carr yesterday at about 4PM. They arrived UPS ground this morning. Pretty cool.
Stu, my Integral cutouts on the stabs had to be trimmed back to fit a 3421. No problem. Just do it.